Google Address Validation

Every property address checked and standardised automatically.

ProhostAI validates and standardises the addresses you enter, so a typo does not quietly break directions, cleaner dispatch and every distance calculated afterwards.

Önizleme

Verify an address existsCheck what was entered against authoritative address data before it is stored.

Google Address Validation çalışma alanınızda böyle görünür.

Şu rolleri güçlendirir

OperasyonMisafir iletişimiGelir

Overview

Address errors are the most expensive small mistake in property management, because nothing announces them. The property saves fine. The listing looks fine. Then a cleaner drives to the wrong street, a guest follows directions to the wrong building, and every "5 minutes from the beach" you have promised turns out to be measured from somewhere else.

Validation catches it at the point of entry. Addresses are checked against authoritative data and standardised into a consistent form, so what gets stored is a real, correctly formatted address rather than whatever was typed at the time.

Everything downstream inherits that correctness — geocoding, nearby places, directions in guest messages, the route a cleaner takes. It is invisible when it works, which is exactly the point.

What ProhostAI can do with Google Address Validation

Address validation runs automatically whenever a property address is entered or changed.

Read

Verify an address exists Check what was entered against authoritative address data before it is stored.
Flag what looks wrong Surface addresses that cannot be confirmed, so they get fixed before anyone is sent there.

Create & update

Standardise the format Store a consistent, correctly formatted address rather than whatever was typed.
Keep downstream data right Directions, distances and dispatch all inherit the corrected address.

Setup

There is nothing to set up. Validation runs whenever you add or edit a property address.

Add or edit a property in ProhostAI and enter its address.
The address is validated and standardised automatically.
Review anything flagged as unconfirmed before saving.

Good to know

There is nothing to connect and no separate screen — validation is part of adding a property.
Coverage and precision vary by country. Some regions validate to the building, others only to the street.
A flagged address is not always wrong; rural and newly built properties are commonly unconfirmed. It is a prompt to check, not a block.
Pair it with Google Maps, which uses the corrected address for distances and nearby places.

FAQ

Do I need to set this up?

No. Validation runs automatically whenever a property address is added or changed — there is no connection step.

Why does it say my address cannot be confirmed?

Usually because the property is rural, newly built, or in a region where address data is less precise. It is a prompt to double-check rather than a refusal to save.

What does a bad address actually break?

Quietly, quite a lot: geocoding, distances to nearby places, directions sent to guests, and the route a cleaner takes. All of it is calculated from the stored address.

Does it work everywhere?

Coverage varies by country. Some regions validate down to the building, others only to the street level.

Does it cost extra?

No. It is part of how properties are set up in ProhostAI, with no separate account or charge.

Daha fazla entegrasyon

Hepsine göz atın